Mounting The Flexible Shaft And Stand - VONROC S-CT501AC Serie Traducción Del Manual Original

To mount an accessory in the flexible shaft (Fig.B)
Lock the spindle by putting the pin (6) in the pin
opening (7). Then loosen the chuck with the chuck
spanner and place the accessory. Keep the pin in
place and tighten the chuck. Make sure to remove
the pin before operating the machine.
Operation
Switch on the machine by engaging the on/off
switch (4) By adjusting the speed adjustment wheel
(5) you can regulate the speed of the Multi tool.
Do not put the machine down when the motor is
still running. Do not place the machine on a dusty
surface. Dust particles may enter the mechanism.
Too high a load at a low speed of the Multi
tool can burn out the engine.

MOUNTING THE FLEXIBLE SHAFT AND STAND

Flexible shaft (Fig. C)
Screw the ring (8) off the chuck and remove it.
Mount the flexible shaft on the Multi tool, placing
the inner shaft (9) in the chuck. The ring of the flexible
shaft (10) can then be fastened onto the Multi tool.
Never operate the axle locking button if the
engine is still rotating.
Stand for the Rotary multi tool
• Assembly the stand (11) on to the workbench
clamp (12).
• Mount the assembled stand on the side of a
workbench or worktop with a maximum thick-
ness of 60 mm.
• The height of the stand is adjustable. Loosen the
top tube of the stand by turning it anticlockwise.
Draw the tube out to its maximum height and se-
cure it by turning the tube clockwise. The height of
the suspension bracket is adjustable by loosening
the black knob. After adjusting the suspension
bracket to the correct height, retighten the knob.
• Attach the Multi tool to the suspension bracket
of the stand; this suspension bracket can be
turned 360°.
Accessories for the Rotary multi tool
Always check that the maximum rpm of the accessory
is suitable for the maximum speed of the Multi tool.
WWW.VONROC.COM
Grinding stones (Fig. D)
When using a grinding stone the first time, use the
dressing stone to balance it. The dressing stone
can also be used for cleaning the surface or to give
the grinding stone a special shape.
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Felt wheels (Fig. E)
The felt wheels should be screwed on the mandrel.
Material
Steel
Aluminium, brass
Plastic
Sanding bands and disc (Fig. F)
Material
Wood
Steel
Aluminium, brass
Plastic
High speed cutter, Diamond wheel point and Drill
(Fig. G)
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Stainless steel brushes and bristle brush (Fig. H)
Material
Stone, shell
Aluminium, brass
EN
Speed setting
-
+
+ -
-
Speed setting
+
+ -
+
Speed setting
+ +
-
+ -
-
Speed setting
Max
+ -
+ +
-
Speed setting
+ -
+ -
7