Operations; Important - Bissell LITTLE GREEN 1400 Serie Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operations

Getting ready
1. To fill the clean water/solution tank.
a. Remove the tank by lifting it straight up
and then away from the unit.
b. Unscrew the black cap at the bottom of
the clean/solution tank.
c. Follow the fill lines on your clean tank
to add the correct amount of hot tap water
(140°F/60°C MAX), portable machine for-
mula, and 1oz of bissell boost if preferred.
Do not boIl oR mIcRoWaVE WatER.
d. Replace the clean/solution tank by
lining up the vertical guides on the left
side of the unit with the indentations on
the clean/solution tank and gently sliding
it down into position.
pre-treating
Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly-soiled areas.
Here's how to do it:
1. Hold the cleaning tool just above the surface
of the carpet or upholstery to be cleaned. Press
the trigger to release a spray of cleaning solution
directly onto the soiled area.
2. Wait 3-5 minutes before cleaning.
cleaning with the tough Stain tool
1. Attach the 3" Tough stain Tool to the handheld
cleaning hose.
2. Plug in the unit and press the power button
beneath the handle to turn it on.
3. Hold the tool 1 inch above soiled surface.
4. Press the spray trigger to mist solution over
and onto the soiled area.
5. Release the spray trigger and gently scrub the
stain.
6. To lift the stain away, apply downward
pressure on the tool and slowly pull it toward
you. Watch as powerful suction removes the
dirt and cleaning solution. Continue until no
more dirt can be removed.
7. As a final step, use "drying strokes" (by not
pressing the spray trigger) to remove as much
moisture as possible. Repeat this step as often
as necessary.
notE: When using bISSEll oxy boost
formula, cleaning continues for 6-8 hours
after application.
www.bissell.com
6
WaRnInG
Keep spray away from face. Failure to do
so may result in personal injury.
1a.
1b.
1d.
1c.

ImpoRtant

Check the manufacturer's tag before
cleaning upholstery. "W" or "WS" on the
tag means you can use your Little Green.
If tag is coded with an "S" (with diagonal
strike-through), or says "Dry Clean Only, "
do not proceed. If manufacturer's tag is
missing or not coded, check with your
furniture dealer.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido