Tools Required - Whittier Wood Products Taylor 159W Instrucciones Para Armar

ASSEMBLY INSTRUCTIONS
Mallet or Padded Hammer, Phillips Head Screwdriver, Wood Glue.
Once you start gluing the stool together, continue until complete.
Before beginning assembly, lay out all the parts to become familiar with their location on the stool.
Note that there are two Left Legs and two Right Legs. When a leg is laying on its side with
the two upper holes facing up, the Left Leg will have the other two holes facing left
and the Right Leg will have the other two holes facing right. (See FIGURE 1.)
FIG. 1
TO ASSEMBLE LEGS AND STRETCHERS:
NOTE: To make attachment of leg assembly to Disc easier, DO NOT insert Stretchers all the way into
the Legs. The shoulder should not be snug against the Leg. Allow approximately 1/4 inch of
the chuck to show. See FIGURE 1A.
1) Lay a Left Leg (A) and a Right Leg (B) so that the lower holes are facing each other. Apply an even
coat of glue to the holes that are facing each other. Insert a Short Stretcher (C) into the upper holes
and a Long Stretcher (D) into the lower holes. See FIGURE 1.
2) Repeat step 1 with the other pair of legs.
159W Taylor Barstool

TOOLS REQUIRED:

IMPORTANT!
IMPORTANT:
READ GLUING HINTS
BEFORE ASSEMBLING!
Not intended for use by children
without adult supervision.
Chuck
STRETCHER
Shoulder
FIG. 1A
LEG
159W — Page 3