auna PRO VHF-400 Duo 1 Manual De Instrucciones página 13

This microphone set offers (two) handheld microphones and a receiver
unit. This has two separate channels that do not interfere. The robust radio
microphones are ideal for use at karaoke or other public events.
• Connect the receiver to a power outlet and insert the batteries into the
microphones.
• Connect the antennas to the receiver (rear: ANT. A/ANT. B) and place
them upright.
• Connect the receiver to your PA or compact system (Audio Out).
• Connect headset microphones to the beltpack (MIC connector on
beltpack).
• Turn on the receiver. The power indicator signals that the receiver is
ready for operation.
• Now switch on the microphones.
• If the receiver is receiving the microphone signals correctly, this is
indicated by the Channel 1 and Channel 2 LEDs.
• It is also possible to use only one microphone alone.
• Adjust the input sensitivity of the microphones at the gain control.
• Adjust the output volume on the receiver.
Microphones/Headsets
• When the battery indicator lights up, the battery is low. To change the
battery, unscrew the cover at the end of the microphone handle or open
the battery compartment on the beltpack. Be sure to use an identical
model and observe the correct polarity (see illustration). The transmit
frequency is located inside the battery compartment.
• Insert the appropriate AA batteries (supplied) into beltpacks or
handheld microphones. Be sure to observe the polarity.
• Set the mixer/PA system to a moderate volume level for the
microphone channels used. At the very end, adjust the output volume of
the receiver using the VOL A/B knobs and mix at the mixing console if
necessary.
EN
13