Operation - Royal Sovereign QS-1AC El Manual Del Propietario

OPERATION

1. Place QUICK-SORT™ Coin Sorter on a level work surface.
2. Connect sorter to 120V outlet.
3. Fully pull out the coin tray before activation.
4. Remove coin tubes. Place coin wrappers into correct tubes. Return all four tubes to proper positions.
5. Drop coins into hopper.
6. Switch the power to ON position, and press the button "Run/Stop"
7. Coins sort automatically.
8. After sorting is finished, press the button "Run/Stop".
Then, remove the tubes.
NOTE : COINS ARE NOT ALWAYS EXACTLY THE SAME. THEY MAY BE BENT OR WORN ON THE EDGES. TO INSURE EXACT COUNTS,
BE SURE THAT THE COINS ARE LEVEL WITH THE TOP EDGE OF THE PLASTIC TUBE EITHER VISUALLY OR BY RUNNING
YOUR FINGER ACROSS THE TOP OF THE FILLED TUBE.
9. Remove filled wrappers by pushing up on the bottom at the base of the tube then pulling from the top.
10. Fold edges of wrapper.
11. Push the overflow tray back.
12. Keep machine out of direct sunlight and moisture.
13. Sorter operates best at room temperatures.
* uSING fLAT WRAPPERS
1. Allow coins to fall directly into plastic tubes. Do not place flat wrappers into plastic tubes while operating.
2. Remove full coin tubes after sorting.
3. Hold a flat wrapper open by placing your index finger slightly inside the end of the wrapper.
Slide the flat wrapper over the top few coins in the tube.
4. While gently pushing the wrapper toward the bottom of the coin tube, tilt the coin tube so that the coins slide into the
wrapper. When the wrapper touches the bottom of the coin tube, hold the tube upright, fold the top of the wrapper.
5. Turn the coin tube upside down and remove the coin-filled wrapper. Fold over the other end of the wrapper.
6