Using Your Humidifier - Essick Air MA0800 Manual De Cuidados Y Uso Del Proprietario

Using Your Humidifier

Refill Display
For maximum run time both the bottle and the
base should be filled. When both the bottle and
the base are empty, the display alternates the
room humidity reading and "F" (FILL), indicating
additional water is required.
Check Filter Indicator
The ability of any humidifier to efficiently supply
humidity output relies heavily on the condition of
the filter. As the filter loads with impurities it
gradually loses its wicking capability. When this
happens, moisture output is reduced and the
humidifier has to work longer to satisfy the selected
setting.
This humidifier has a check filter reminder timed to
appear after 720 hours of operation. When the
display shows an alternating "CF" and "room
humidity" setting at 5 second intervals it is a
reminder to check the filter condition.
NOTE: Some areas have high water mineral content causing the need for more
frequent filter changes.
Reset the Check Filter "CF" function each time you replace a filter by unplugging
the unit from the power source, then plug it in again.
Refer to Replacement and Care of Filter on page 8. If a build-up of deposits or
severe discoloration is evident replace the filter to restore maximum efficiency.
Control lock
To avoid unwanted tampering with the humidifier
settings the controls can be locked.
Activation Procedure
After the humidifier functions have been set up, hold
the power button down for 5 seconds. The display
will show "CL" for 2 seconds; release the power
button and the control will resume the display of the
room humidity. The humidifier will continue to
function with the locked in settings. If buttons are
operated while "CL" is active, the "CL" is displayed and settings are unaffected.
Deactivation Procedure
To deactivate the "CL" function simply
press and hold the power button for 5
seconds. "CL" will flash at the rate of 1
second on and 1 second off for a period of 2
seconds and then resume the display of
room humidity.
Humidistat
The humidistat located on the power cord
senses the percentage of humidity in the
air. It causes the humidifier to cycle on
7