Publicidad
FUNCTIONS
Front Panel
1
8
2
3
4
5
6
7
17
18
19
THE CHANNEL
: These switches allow to choose which of
1 Input assign switches
.-
the following backpanel inputs will be audible:
Phono (turntable MM cartridge) or CD or Line (CD and Line inputs
are same characteristics)
Allows the adjustment of the channel input
2.-
Gain Control:
sensitivity regarding the different source levels. Each channel has
an optical check up by means of the 10 LED bargraphs of the level
meter.
3 Channel EQ:
.-
Independent control is provided for the high
(13KHz), the mid (1KHz) and the low (70Hz) frequency band.
Please be aware, that any boosted frequency band will increase the
total level and decrease the level headroom.
4 Channel level meter:
.-
The meter display the channel level before
channel fader. To set the channel at the right level, when in play
back, set the Gain in a way that all green Leds light and the yellow
and red only blink.
5 Headphones assign switch (Cue):
.-
assign any of the input channels to be replayed on the headphones.
Please note that you can only hear the required source if the input
assign switch is switched to the respective position and the source is
in play mode.
By means of these controls, you determine the
6.-
Channel fader:
part of the overall level, that a specific channel contributes. Please
be aware of the final output level to be adjusted by the Master and
2
1
With these switches you can
mcx
9
Booth controls. Furthermore, the level of the channels can depend
on the setting of the Crossfader if these channels are assigned to it by
means of the Crossfader assign control. To be in-field replaceable,
this part is front-detachable. For replacement, switch off the unit
and unscrew the 2 outer screws of the crossfader and remove the
part; detach the connector and replace the part. Plug in the connector
and screw the new part to the main body again.
7 Crossfader selector: By means of this control we can send the
.-
channel signal to:
-A:Crossfader Left and Left bank of Kill effect
-B: Crossfader Right and Right bank of Kill effect
-Bypass: Send channel signal strait to Master Bus
8.-Microphone connector
MASTER SECTION (and Crossfader)
9.-Power switch:
With the AC plug plugged into the wall outlet, the
unit may be switched on by means of this switch; a second press of
the switch will switch the unit off again. Once the mixer is switched
on the FX Section displays will light up.
care of switching on your mixer first and your amplifier at last to
avoid switching noise damaging your speakers; for switching off,
switch off your amplifier first and your mixer at last.
10
11
12
21
22
23
24
25
26
27
13
28
14
29
15
30
16
20
Always take
Attention:
Publicidad
