Publicidad
FUNCTIONS
Rear Panel
10
INPUTS
- Insert here connectors from turntables (MM)
1.- Phono inputs L,R
type
2.-
Cd
level inputs L,R
- Insert here connectors from any line level
signal device. That is CD Player, MD player, Cassette Player etc.
3.- Line level inputs L,R
- Same as point (2)
4.- Mic input (Jack 6.3)
duplicated. You have one at the front panel and another at rear panel.
That is a Jack 6.3.
- Same as point (2)
5.- Line level inputs L,R
OUTPUTS
6.- Master output L,R (RCA)
Normally RCA output are used at domestic setups or cable lines are
short.
7.- Balanced Master output -
connectors are typically used to connect to the amplfier system for
Connectors
RCA
Line and Phono inputs
Several outputs
XLR3 o Canon
Master Balanced output
4
3
2
1
6
- Microphone has the input connector
- Connect to the amplfier system.
Balanced XLR3 or Cannon
Shield:sleve
Hot: tip
Cold: ring
8
9
professional use. Specially when cable lines are long and therefore
can caught unwanted noise.
8.- Booth output L,R
for monitoring at the DJ cabin (when avaialble).
9.- REC L,R
volume control. It can be used to record even while the master volume
is off.
10.- AC Input
Connect it to the wall outlet socket.
Always assure that the tension and frequency of the outlet matched
the specified at the mixer.
11.- Ground connector
to eliminate electrical hum. Ground connectors are usually supplied
with turntables.
Jack 6.3 mono
Rear panel Microphon
Jack 6.3 stereo
Headphones
mcx
11
4
7
- This is a second Master output normally used
- The record output is not affected by the Master
- Input connection for the inboard power supply.
- Connects to the turntable ground connector
5
Publicidad
