Descargar Imprimir esta página

General Instructions - JANE MATRIX PLATFORM Instrucciones

Plataforma

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1

GENERAL INSTRUCTIONS

In order to protect the baby correctly and guarantee his comfort and safety
in the car, it is necessary to follow the instructions below:
The Matrix Platform can be installed on the
front seat, if there is no airbag, or on the
back seat. It is advisable to install it on the
back seat. If you install it on the front seat
of the car, the seat must not have an airbag,
or it must be disconnected.
The Matrix platform can only be installed
using ISOfix fasteners. It has a leg as an
anti-swivel mechanism, adjust it correctly
so that it is supported by the floor of the
vehicle.
Not all systems are the same, so we advise
you to check this in the vehicle in which the
platform is going to be installed. To install
the platform, read the instruction manual
for your car, as this will indicate which seats
are compatible with the platform. The Ma-
trix platform is compatible with the ISOfix
categories: Classes C, D, E and G.
It is very important NOT to use second-hand
products, since JANÉ can only guarantee
the complete safety of articles used by the
original buyer.
JANÉ recommends that the Matrix platform
should be replaced by a new one when it
has been subjected to severe strain in the
event of an accident.
Regularly check that the ISOfix fasteners
and the anti-swivel leg are correctly con-
nected and/or adjusted.
This platform has been designed for use in
the car, therefore, it should not be used out
of the car.
19

Publicidad

loading