Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
med time at the end of which it stops auto-
matically. By pressing the key, you can
successively start and stop the pump.
·Put the overflow drain plug and filters in
place again.
·Turn the main switch off and close the lid.
Models 'BP'
Draining of the Air gap-Break tank: In case
of extended non-utilization of the machine,
the tank should be emptied. To do so :
1.Drain the wash tank
2.Close the water inlet.
3.Close the hood: water will flow into the
wash tank by means of the pressure
pump.
4.Drain the wash tank.
When boiler draining is done by the techni-
cal assistance service, the water break-tank
is emptied through the boiler.
TANK CLEANING
The tank should be cleaned after every
washing process, at the end of the day,
proceeding as follows: Fig.C
·Open the hood and take out the overflow
pipe.
·Open the hood, remove the top filters
from the tank and clean them carefully.
(Never remove the filter from the powered
pump (5) when the tank is dirty.)
·Drain water out of the tank.
·Once the tank is totally empty, remove the
filter from the powered pump (5) and
clean it.
·On models 'B' with a drain pump, also remo-
ve the screwed-on filter of the drain pump
(3) to clean it. As shown on Figure C, give
the filter (3) a quarter of a turn to unscrew
it. After cleaning, screw the filter on again.
·To clean the interior of the wash tank,
close the lid and start the machine (after
having previously removed the drain plug).
In this way, water will enter via the rinsing
dispersers and the machine will clean
itself. This operation should be carried out
for 2 to 3 minutes.
·Finally, clean the bottom, walls and inte-
rior of the tank.
·Spray arms must be cleaned periodically. If
rinsing is deficient, the cause may be an
obstruction of the jets. In this event, dis-
mount the arms and clean the jets.
·The outside of the machine MUST NOT BE
washed under a direct water jet; instead
you can use a wet cloth and any ordinary
detergent.
·DO NOT USE any abrasive detergent
(etchant, concentrated lye, etc.) nor any
scourer or scraper containing normal steel
that will cause rust to develop on the
machine.
OTHER IMPORTANT REMARKS
·Before cleaning, servicing or repairing the
machine, it is necessary to unplug it from
the mains.
·When the appliance is going to be inactive
for a long period of time or at night, the lid
should be kept open for aeration and avoi-
ding nasty smell.
·In case of a drain pump failure:
1.Drain the wash tank into a container
until the water level drops below the
drain plug.
2.With the drain plug in place, remove the
front bottom panel and change the pump
(this can be done without moving the
machine). In order to drain the dishwas-
her manually, connect a drain hose to the
collector. On pulling out the drain plug,
water flows out of the tank by gravity.
·In the event the power supply cable should
get damaged and have to be replaced, the
repair may only be done by a SAMMIC
approved assistance service.
·Airborne noise: the emission noise level
measured on a typical machine is 71 dB(A)
at a distance of 1m.
9
ENGLISH
Publicidad
Tabla de contenido
