Master/Slave Mode (Cont.); Configuration (Dmx); Dmx Personality And Starting Address; Custom Color Adjustment - Chauvet DJ GigBAR IRC Manual Del Usuario

Master/Slave
Mode (Cont.)
Configuration
(DMX)
DMX Personality
and Starting
Address
Custom Color
Adjustment
GigBAR™ IRC User Manual Rev. 2
For the master:
1. Connect the DMX output of the master to the DMX input of the first slave unit.
2. Set the master unit to operate in either Automatic or Sound-Active mode.
· Make sure the master is the first unit in the DMX chain.
· Never connect a DMX controller to a DMX chain configured for Master/Slave operation
because the controller may interfere with the signals from the master.
· Do not connect more than 31 slaves to the master.
Set the product in DMX mode to control with a DMX controller. The product uses a 3-pin DMX
cable.
1. Connect the product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket
on the product.
When selecting a DMX starting address, always consider the number of DMX channels used by
the fixture. If you choose a starting address that is too high, you could restrict the access to
some of the product's channels.
The GigBAR™ IRC uses 3-, 8- and 19-channel DMX personalities, which means the highest
DMX address you can use is 494.
If you are not familiar with the DMX protocol, download the DMX Primer from
http://www.chauvetlighting.com/downloads/DMX_Primer_Rev6_WO.pdf.
To select the DMX personality and starting DMX address, do the following:
1. Press <MENU> repeatedly until the desired DMX personality (3 CH, 8 CH, or 19CH) blinks
on the display.
2. Press <ENTER> and D** blinks on the display.
3. Use <UP> or <DOWN> to select the starting address (d001–d512).
4. Press <ENTER> to put the fixture in DMX mode. The display will continue to blink.
To set both the Par and kinta to a custom color, do the following:
1. Press <MENU> repeatedly until CoLo blinks on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to scroll through R** (red), G** (green), or B** (blue).
4. Press <ENTER> to select the color.
5. Use <UP> or <DOWN> to adjust the color saturation (X000–X255).
6. Press <ENTER>.
7. Repeat Steps 3 through 5 for each color.
Page 21 of 96