Publicidad
Idiomas disponibles
Idiomas disponibles
Warming
Drawer
Figure 7
7. Install Anti-Tip Bracket
WARNING
RANGE TIPPING HAZARD
•
All ranges can tip and injury could result. To
prevent accidental tipping of the range,
attach it to the wall, floor or cabinet by
installing the Anti-Tip Device supplied.
•
A risk of tip-over may exist if the appliance is
not installed in accordance with these
instructions.
•
If the range is pulled away from the wall for
cleaning, service, or any other reason, ensure
that the Anti-Tip Device is properly
reengaged when the range is pushed back
against the wall. In the event of abnormal
usage (such as a person standing, sitting, or
leaning on an open door), failure to take this
precaution could result in tipping of the
range. Personal injury might result from
spilled hot liquids or from the range itself.
1. Adjust height of range and level by rotating the
adjustable leg supports on the bottom of the
range, using 1-1/4" wrench.
2. Measure to locate bracket position as shown in
Figure 8.
3. Secure bracket with 2 screws adequate for
mounting surface, not included. (i.e.; for wood
floor use wood screws for concrete floor use
concrete anchors and screws.).
Steps 7 and 8: Final Steps
Wrench
Adjustable
legs
Cabinet Sidewall
Figure 8
8. Complete the Installation
1. Move range close enough to the opening to plug
into the receptacle.
2. Slide range into position ensuring that the left
back leg slides under the anti-tip bracket. Range
will sit 3/4" away from back wall when properly
installed.
3. Carefully tip range forward to ensure that the anti-
tip bracket engages the range back brace and
prevents tip-over.
4. Turn on electrical power. Check range for proper
operation as described in Use and Care Manual.
Note: if display flashes and beeps, the wiring is
incorrectly installed. Immediately disconnect power at
breaker and return to step 6: CONNECT ELECTRIC.
Flush
Publicidad
