Descargar Imprimir esta página

Troubleshooting - FAR EC-15 CI Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
ENGLISH
Place the coffee pot onto the hot plate, ensuring that its central line is aligned with
2.
that of the brew basket.
Press the button once for the filter coffee function; the function light (red) comes
3.
on and water starts to flow automatically after a moment.
Once the amount of water has reached a cupful, press the button again to switch
4.
off the appliance.
Leave the solution to act for 15 minutes, then repeat steps 3 to 5.
5.
Switch on the appliance and let the water flow out until the tank is completely
6.
empty.
Rinse the device through with water at least 3 times.
7.

TROUBLESHOOTING

Problem
Cause
Water is leaking
The coffee pot is not
from the coffee pot
correctly positioned.
or from the coffee
pot lid.
The level of water in
the tank exceeds the
maximum level.
The espresso flows
The coffee is ground too
too slowly (not
finely.
just for the coffee
maker with pump).
The metal parts
The limescale remover
of the tank have
used is not the type
rusted.
recommended. It can
corrode the metal parts
of the tank.
GB-14
Solutions
Align the central line of the
coffee pot with the opening of
the brew basket's liquid output.
The water level in the tank
must be between the lowest and
highest levels.
Use ground coffee 1#.
Use a limescale remover
recommended by the
manufacturer.
Problem
Cause
Water is leaking
There is a lot of water on
from the bottom of
the hot plate.
the coffee maker.
The coffee maker is
malfunctioning.
Water is leaking
There is ground coffee on
from the outer edge
the edge of the filter.
of the filter.
The espresso has
You have not rinsed the
an acidic taste
appliance properly after
(like vinegar).
descaling.
The ground coffee has
been stored in a hot and
humid place for a long
time. The ground coffee
has expired.
The coffee maker
Its plug is not correctly
will not switch on.
connected.
The steam does not
The green
light
foam the milk.
flashes.
The jug is too big or its
shape does not fit.
You have used skimmed
milk.
ENGLISH
Solutions
Clean the hot plate.
Contact an approved repair
centre to have the appliance
repaired.
Remove it.
Rinse the coffee maker several
times, following the instructions
in the "Before using for the first
time" section.
Use cool ground coffee. Store
unused ground coffee in a cool,
dry place. After opening a packet
of ground coffee, close it gently
and put it in the refrigerator to
keep the coffee cool.
Connect the appliance's plug
correctly to an electrical socket.
If the appliance still does not
work, contact an approved repair
centre and have it repaired.
The steam can only be used to
make foam after the green
light comes on (only for the
coffee maker with pump).
Use tall, narrow jugs.
Use whole or semi-skimmed
milk.
GB-15

Publicidad

loading