Uline Better Pack 333 Plus Guia De Inicio Rapido página 3

AdjUSTMENTS
TAPE WIDTH
The adjustable roll guides in the tape basket should be
properly set for the width of tape being dispensed. The
roll of tape should be centered between the frames
by threading the tape loosely between the roll guides
which engage in slots in the basket and roll guide
separator.
To set the roll guides in position, lift them out of the slots
in the basket and tie rod. Slide to the desired position
and drop guides into slots in the bottom of the basket.
(See Figure 5)
Figure 5
Slots
WATER LEvEL ADjUSTMENT
The amount of water required for proper moistening
of different grades of tape will differ. Heavier glues
or reinforced tapes will normally require higher levels
of water. Water level is controlled by the Water Level
Adjustment Screw located in the projecting portion of
the water tank. (See Figure 6)
To raise the water level, turn the screw out in the
counterclockwise. To decrease the water level, turn the
screw in the opposite direction.
PAGE 3 OF 8
SETUP INSTRUCTIONS CONTINUEd
Roll Guide
Figure 6
Water Level
Adjustment
Screw
REPEAT LENGTH STOP
The Better Pack® 333 Plus is equipped with a feed stop.
To set for desired length, pull outwardly on the feed stop
until the pin disengages the hole in the drum skirt. Then
slide the feed stop assembly until the length desired
is set on the scale just above the feed stop assembly.
Release the knob, being sure the pin on the feed stop
engages with the proper hole in the skirt. (See Figure 7)
CRANk HANDLE
If desired, the crank handle can be reversed.
PRESSURE PLATE WEIGHTS
The pressure plate, which rests on top of the brushes,
has removable weights. (See Figure 8) The number of
weights can be varied to suit the tape being dispensed.
Heavyweight tapes require more weight inserts than
lighter tapes. The suggested number of weights is as
follows:
35 lb. kraft Tape
60 lb. kraft Tape
Reinforced Tape
The weights can be added or removed by pushing
them in or out from each side.
NOTE: If the machine consistently jams, there
is too much weight on the pressure plate and
some should be removed.
Drum
Skirt
Hole
Feed
Stop
Figure 7
0 to 1 Slug
1 to 2 Slugs
2 to 3 Slugs
Figure 8
Weights
0913 IH-35