Start-Up Procedure; Spray Nozzle Selection; Pump Specifications; Engine And Pump Features - Coleman Powermate PW0872650 Manual Adicional

START-UP PROCEDURE

PRE-START PREPARATION
Before starting the pressure washer, check for loose or
missing parts and for any damage which may have occurred
during shipment.
Handle Installation
Install handle and hose hook as shown in Figure 1.
START-UP PROCEDURE
1. Make sure water supply is connected and turned on.
2. Release gun safety if locked.
3. To allow air to escape from the hose, squeeze trigger on
the gun until there is a steady stream of water coming
from the nozzle.
4. Remove any dirt or foreign matter from the gun outlet and
the male connector of the wand.
5. Insert the nozzle wand into the gun wand and tighten the
fitting securely.
STARTING THE ENGINE
1. Check oil and fuel level.
2. Set the engine switch to the "ON" position.
3. Push the primer as necessary.
English
4.
5.
provided with your pressure washer.
Figure 1
cleaning increases as you move closer to the surface.
very aggressive. Use with extreme caution to prevent damage
to the surface being cleaned or injury to persons or animals.
most cleaning applications. It provides narrow coverage and a
highly powerful water stream.
both a medium coverage and water stream. Best used for
flushing dirt and debris off surfaces.
cleaning with the widest coverage over a larger area with a
powerful water stream.
and a wide coverage. Used primarily when operating the
chemical injector to apply chemicals.
Maximum Inlet Pressure . . . . . . . . . . . . . . . . . .Up to 90 PSIG
RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3600 RPM
Temperature of Pumped Fluids . . . . . . . . . . . . . . . .Up to 80°F
Inlet Ports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/8" BSP
Discharge Ports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/8" BSP
Crankcase oil Capacity . . . . . . . . . . . . . . . . . . . . . . . .4.7 fl. oz.
Pump oil . . . . . . . . . . . . . . . . . . . . . . .SAE 30W Nondetergent
met if the pump is to operate beyond one or more of the limits
specified above.

ENGINE AND PUMP FEATURES

2
Squeeze trigger on pressure washer to release pressure
while pulling on the engine starter rope with a fast steady
pull. Pressure may otherwise build up making starting the
unit difficult.
As the engine warms up, readjust the choke.

SPRAY NOZZLE SELECTION

Following is information concerning the five nozzles
NOTE: The force of the spray on the surface you are
0° High Pressure (Red): The water stream discharged is
15° High Pressure (Yellow): This is the nozzle used for
25° High Pressure (Green): Use of this nozzle offers
40° High Pressure (White): This nozzle is used for
65° Low Pressure (Black): Provides low pressure spray

PUMP SPECIFICATIONS

Consult the factory for special requirements that must be