Assembly Of Parts - SATA AE1015 Manual De Instrucciones

4.2 Assembly of Parts

4.2.1 Assembly of arm
Please read this Manual carefully before the installation and commissioning. Any unauthorized modifications to the machine parts may
cause damages to the machine.
Installation and commissioning personnel shall have certain electrical knowledge.
Operators shall be specially trained and qualified.
Please check the equipment list carefully before installation. In case of any doubts, please contact the dealer or the Company immediately.
To ensure the smooth installation and commissioning, the following common tools shall be prepared:
Monkey wrench (10")
Sleeve wrench
Internal hexagon wrench
Screwdriver
Hammer
Multimeter
4.2.2 Unpacking.
4.2.3 Unpack the machine according to the unpacking instructions on the packaging box; remove the surrounding packaging materials;
check if the machine is damaged during transportation and if the accessories are complete.
4.2.4 Transport the packaging materials away from the working site and dispose of them properly.
4.2.5 Installation
AE1015/AE1015-3/AE1015H/AE1015H-3
2 pieces
1 set
1 set
1 set
1 piece
1 piece
中文
EN DE
Fig. (4-1) After opening the packaging box, take out the
accessory box (1), Tire-Pressing Arm (5) and Column
Assembly (2); fix the box in place according to the Fig. (4);
and unscrew the hex head screws (4), spring washers and
plain washers from the box.
Fig. 4-1
RU KO PT JA ES
43