Assembly Of Parts - SATA AE1017H Instrucciones De Uso

4.2 Assembly of parts

4.2.1 Assembly of column
Please read this manual in detail before installation and commissioning. Any unauthorized modification to its parts may cause damage to
the machine.
Installation and commissioning personnel shall have a certain level of electrical knowledge.
Operators shall be specially trained and qualified.
Please check the equipment list carefully before installation. In case of any doubt, please contact the dealership or company immediately.
To ensure smooth installation and commissioning, the following common tools shall be prepared:
Monkey wrench (10")
Sleeve wrench
Internal hexagon wrench
Screwdriver
Hammer
Multimeter
4.2.2 Unpacking.
4.2.3 Unpack the machine according to the unpacking instructions on the packaging box, remove the surrounding the packaging
materials and check if the machine was damaged during transportation and if the accessories are complete.
4.2.4 Transport the packaging materials away from the working site and dispose of them properly.
4.2.5 Installation of column.
44
AE1017H
2 pieces
1 set
1 set
1 set
1 piece
1 piece
中文
EN DE
Ground the machine cabinet base and place it stably
on the site. Unpack the accessory box, take out the
shaft assembly diagram (4-1) and wipe it clean.
Fig. 4-1
RU KO PT JA ES