Operation Test - SATA AE1017H Instrucciones De Uso

4.2.14 Ventilation test
When the air source is open, press the air valve locking button (Fig. 2-1 B) to lock the push-pull arm, and depress the column tilt pedal (Fig.
2-1 H) to make the column tilt backwards by about 25 . The moving speed of the column has been adjusted to about 2 seconds for one-
way motion. If the speed later becomes too high or too low, it may be adjusted via the valve controlled by the chassis leaning pedal (Fig. 2-1
H): release the copper silencer throttle valve on the air valve and turn the throttle valve clockwise to decrease the speed, and vice-versa.
4.3 Commissioning
All electrical works shall be performed by qualified personnel, and the correct power supply shall be provided.
Make sure that the phases are connected correctly. Improper electrical connections may damage the motor
and invalidate the warranty.
Check if the characteristics of your system meet the requirements of the machine. If the operating voltage of the machine must be
changed, adjust the terminal block according to the electrical diagram in Chapter X. Connect the inlet of the air source triplet (Fig. 2-1 S)
with the compressed air system of the total air source.
Connect the machine to the electrical system. The electrical system shall be equipped with a safety line and
grounded according to local national standards. If necessary, the equipment shall be fitted with leakage
protection devices to ensure the safe operation of the equipment. If a power plug is not installed in the
tire changer, the user shall install a plug which has a minimum current of 16 A and which complies with the
regulations for machine voltage.

4.4 Operation test

With the foot pedal (Fig. 4-17 K) depressed, the large plate will rotate clockwise. With the foot pedal released, the large plate will rotate
counterclockwise.
If the large plate does not rotate in the above directions, swap the two lines on the 3-phase binding post.
48
AE1017H
中文
EN DE RU
Fig. 4-11
KO PT JA ES