Test In General Mode - SATA STV Serie Manual Del Uso

Test in general mode:

1） Verify that the software is connected to the torque tester （via WIFI or serial port） and that the data interaction is normal.
2） Verify that the detection mode is general mode.
3） When setting the torque, input the set value of the torque （in this case, 30Nm）, and write it through the " 写设定值 "button,
check whether the actual set torque is the set 30Nm.
4） You can choose whether you need to input the serial number of the wrench （the input serial number can be reflected in the
export report）, and then the wrench selection drop-down box is locked （activated in verification mode）.
96473/96474
中文
EN DE RU KO PT JA ES
61