INSTRUCTIONS FOR PLACING THE FILTERS AND CLOSING THE PURIFIER
1.
Place and center the absolute filter in its right position, and tighten all 4 locks
to the maximum
2.
Place the flap of the GRSystem filter below lateral guides, slide it through its
guides to the end and lower it by 2 cm
3.
Slide the pre-filter through the lower guides to the end
4.
Place the metal panel in the correct position, considering that the
label with the serial number of the machine is on top. Then, tighten the 6
screws that will seal the equipment
5.
Position the white outer panel about 5 cm from the bottom of the purifier,
and then press towards the appliance until it adjusts, lowering those 5 cm until
it is totally fixed
Please, contact Eurofred or your local distributor for replacements.
IMPORTANT: It is important that only original filters supplied by Zonair3D
Eurofred are used to ensure the desired result and correct operation of the
equipment. The guarantee will become void if filters other than those supplied
by Zonair3D
are used.
TM
MANAGEMENT OF USED FILTERS
The filters of this purifier must be taken to their local green point for proper
disposal, so that they can be managed sustainably and do not create problems for
the environment.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The european directive 2012/19/UE on Waste Electrical Equipment (WEEE),
specifies that old household electrical appliances must not be disposed of with
the normal unsorted municipal waste.
The crossed out "wheeled bin" symbol reminds you of your obligation to
dispose of the appliance correctly.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
/
TM
Pure Airbox Home "S"
25