Klarstein 10030663 Manual Del Usuario página 27

Universal 5L beer keg
1. Before piercing the plug on the top of the keg, you must always follow the instructions marked on the
keg to eliminate the excess gas and ensure that the keg has rested long enough to avoid foam coming
out through the tap faucet.
2. Uprightly direct the piercing pin against the sealant on the upper centre of the keg (maybe you need to
tear off the marking ring or change a proper sealant), press the piercing pin/keg lifter to poke the sealant
and then push the piercing pin all immerse in the keg quickly. To assemble the tap mechanism until you
hear a cling sound that will indicate the tap mechanism fixes on the beer keg.
Beer dispens-
ing unit
Keg seal
Beer keg
3. Open the beer cooler with 30-40N strength and place the well-assembled keg into the cooling cavity;
Connect the CO2 connector tube and beer outlet tube with the keg lifter tube connector.
NOTES: make sure all connection of tap mechanism is well connected, and without damage. And
make sure tap valve is on close status, and the CO2 pressure regulator knob is at "Off" status.
closed
open
27
Beer connector
CO connector
2