Home Decorators Collection SKU 1002099626 Manual De Instrucciones página 2

Thank you for purchasing this Home Decorators Collection exterior wall lantern.
This product has been manufactured with the highest standards of safety and
quality. The finish of this lantern is weather resistant but over time will naturally
weather and fade.
WARNING:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FEATURES:
1. MOTION SENSOR FUNCTION-The motion sensor activates at dusk and automatically turns the
light on when it detects a moving heat source such as people and vehicles are within its coverage
area. The motion sensor will remain active throughout the night and deactivate at dawn.
(Note: When power is first applied, the light will come on for about 20 sec. to allow the electrical
current to stabilize. Once stable the software in the Motion Sensor's Test Mode and Auto Mode
functions can be carried. The sensor has 2 knobs one is to adjust the sensitivity and the second is a
shut off delay timer. (See fig.1) The motion sensor should be turned as Fig.2 to adjust the knobs
location from the back to the side for accessibility when needed to adjust the settings.)
Works at
Activated by
On time
Shut-off delay time
Page 2
TEST MODE
Day & Night
Motions
As motion existing As motion existing
5Sec.
5'
1'
Auto
10'
Test
TIMER
21Ft
13Ft
5Ft 30Ft
SENSITIVITY
AUTO MODE
Night only
Motions
10Sec.～10Min.
Fig.1
Fig.2
TURN
Light Fixture body rotates to the right for easy
access to motion sensor settings