Publicidad
Section 8
Check the Seal for Fit
Step 1
Step 1
With the Sunrider for Hardtop latched,
check the seal between the Sunrider for
Hardtop and the rear hardtop. The seal
should fit well and cover the channel
between the Sunrider for Hardtop and the
rear hardtop, with no kinks, folds, or bulges
visible from the outside.
If the fit is not good, unlatch the Sunrider for
Hardtop, and go back to Step 1 on Page 10,
making sure that the seal fit is good before
latching the Sunrider for Hardtop again.
P11 - 52450 Rev. E 0416
NOTICE
Check the seal position and adjust as
required to be sure it fits and covers the
channel between the rear hardtop and
the Sunrider for Hardtop for maximum
water leak protection.
Jeep hardtop seals vary by model year.
Some seals contain stuffers in the
center section that may cause the
Sunrider for Hardtop rear seal to
stick out in the center.
Installation Instructions - Sunrider for Hardtop
Page 11
© 2016 Bestop, Inc.
Publicidad
