8. Insert the pin shaft into the left hole on the
lower hinge, then secure the shaft with the washer
and nut.
9. Install the lower hinge on the left side of the
cabinet.
10. Remove the screw that secures the door stop
from the bottom right of the freezer compartment
door, then remove the door stop and install to the
bottom left side.
Freezer door
11. Install the freezer compartment door.
12. Move the door bushing from the top right side
of the freezer door to the top left side of the door.
And move the left hole cover to the right side.
Door
bushing
13. Remove the center hinge screw hole plug on
the left side of the cabinet, then install in the screw
holes on the right side of the cabinet.
Pin shaft
Door stop
Hole cover
Screw hole plug
14. Install the center hinge to the left side with the
two screws you removed previously.
Freezer compartment door
Center hinge
Door bushing
15. Get the left door stop from the accessory bag,
install it on the bottom left side of the refrigerator
door.
Refrigerator door
16. Install the Refrigerator compartment door.
17. Move the door bushing from the top right side
of the Refrigerator door to the top left side of the
door. And move the left hole cover to the right side.
Door
bushing
18. Remove the screw that secures the hinge screw
hole cover from the top left side of the cabinet,
remove the cover and secures the cover on the top
right side of the cabinet.
Screw
Hinge screw hole
19. Secure the upper hinge to the top left side of
the cabinet with the three screws you removed
previously. Before you tighten the upper hinge
screws, make sure that the top of the door is level
with the cabinet and that the rubber gasket makes
a good seal.
18
Screws
Left door stop
Hole cover