Wall Mounting; Intended Use; Assembly And Adjustments - Craftsman 20V Max CMCE500 Manual Del Usuario

English

Wall Mounting

These chargers are designed to be wall mountable or to
sit upright on a table or work surface. If wall mounting,
locate the charger within reach of an electrical outlet,
and away from a corner or other obstructions which may
impede air flow. Use the back of the charger as a template
for the location of the mounting screws on the wall. Mount
the charger securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long, with a screw head
diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Versatrack
CRAFTSMAN chargers can be mounted to the wall using
CRAFTSMAN Versatrack Trackwall. Hooks and accessories
are sold separately. Please refer to the Versatrack Trackwall
accessory sheet for further information.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

Intended Use

This oscillating multi-tool is designed for professional detail
sanding, plunge cutting, flush cutting, removal of excess
materials and surface preparation applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This oscillating multi-tool is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Risk of lacerations or burns. Do not touch
the sharp edges of accessories at any time. Do not
touch work piece or blade immediately after operating
the tool. They can become very hot. Handle carefully.
Always allow accessories and work piece to cool
before handling.
Installing/Removing Accessories (Fig. B–D)
The tool features an exclusive Tool-Free System for faster
accessory changes and adjustments without the need for
wrenches or hex keys like other oscillating tool systems.
1. Grasp the tool and squeeze the Tool-Free accessory
clamp's lever.
4
2. Clean any residual debris from the tool shaft
the Tool-Free accessory clamp holder.
3. Release the Tool-Free accessory clamp lever.
8
4. Slide the accessory between the shaft and the
accessory holder making sure the accessory
engages all of the pins
with the shaft as shown in Figure B.
5. Some accessories, such as scrapers and blades can
be mounted at an angle if required as shown in as
shown in Figures C and D.
Fig. B
9
Fig. C
Fig. D
Installing/Removing Sanding Sheets
(Fig. E)
A diamond shaped platen uses a hook and loop adhesion
system to attach the sanding sheets. The platen allows you
to use it on large flat surfaces and tight spots or corners.
1. Attach the sanding platen accesory as described under
and
8
Installing/Removing Accessories.
2. Align the edges on the sanding sheet with the
edge of the sanding platen and press the sanding
sheet onto the platen.
9 on the holder and is flush
8
4