GE AFQ08 Manual Del Propietario E Instrucciones De Instalación página 13

PLACE, ASSEMBLE AND INSTALL
8
THE SUPPORT BRACKETS
A Determine the position that the V-support
will be placed within the support rail by
placing the support rail against the back
edge of the stool.
NOTE: If the wall extends past the sill,
note the nearest side hole in the support
rail that is past this construction.
OUTSIDE
Support rail
Note the nearest
side hole location
that is past the sill.
B
Assemble the V-support to the support rail
using 2 Type C nuts, lock washers and
bolts, at the location noted. The shortest
portion of the V-support should be placed
facing the neck of the support rail. Repeat
for second V-support and support rail.
Support Assembly
Type D bolt
Thread a Type D bolt about 1/2 of the way
into the outer face of the shortest angle of
each V-support.
Installation Instructions
INSIDE
Stool
Mount to the
nearest side hole
location that is
past the sill
Neck
Type C
nuts and
bolts
(2)
C
Line up the V-notches in the support
assemblies on the left and right marks on
the stool. Make sure that the support rail
is against the back of the stool and drill
two 1/8" pilot holes into the stool through
the holes in the support rail neck. Attach
the support assemblies to the stool using
2 Type B screws in each assembly.
Support rails
Adjust the Type D leveling bolts against
the outside wall so that the assemblies
have a slight tilt to the outside. Use a
level; about a 1/2 bubble will be the
correct slant to the outside.
1/2 Bubble
Support bracket
Type D
leveling bolt
NOTE: Use a wood block between the
leveling bolts and the wall if the wall
is weak or if the supports of the air
conditioner fall between the studs
in the wall.
D
Attach the adhesive side of the window
stool seal (thin, adhesive-backed) to the
window stool.
13
Type B
wood screws
Sill
Stool
INSIDE
Type B wood screws
Stool
INSIDE
Window stool seal