Silvercrest Z31738 Instrucciones De Utilización Y De Seguridad página 21

If the above instructions are not
complied with, the batteries may
discharge themselves beyond their
end voltage. There is then a danger
of leaking. If the batteries have
leaked inside your device, you
should remove them immediately
in order to prevent damage to
the device!
Avoid contact with the skin, eyes
and mucous membranes. If you
come into contact with corrosive
battery fluids, flush the affected
area thoroughly with clean water
and contact a doctor immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the base with the container
turn the top counter­clockwise (see Fig. A)
1
until the arrow on the top
the symbol on the base with container
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
base with container
3. Pull the motor
3
container .
6
4. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
5. Fill up the base with container
corns or coarse salt. The best result will be
103639_silv_Salz_oder_Pfeffermuehle_Content_ES.indd 21
firmly and
6
is aligned with
1
6
from the
1
.
6
carefully off the base with
with pepper­
6
achieved when filling the base with container
up to 75 %.
6. Put the motor
3
ner . Be sure to place the notch on the motor
6
marked with a white arrow into the respective
protrusion on the base with container (see Fig. B).
Indication: Please make sure that the contacts
, face each other (see fig. A).
4 5
7. Put the top back on the base with con­
1
tainer .
6
8. Hold the base with container
turn the top clockwise (see Fig. B) until the
1
arrow on the top
on the base with container
Using of the salt
and pepper mill
P ull off the aroma seal cover
tom of the base with container
(see fig. B).
P lease keep the switch
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
A djusting the grinding level
T urn the adjustable screw
receive a finer grinding level (see fig. C).
T urn the adjustable screw
receive a coarser grinding level (see fig. C).
. Turn the top of the device and press the switch
to remove residues from the grinding mechanism.
Note: Choose a coarser setting if the grinding
mechanism stops rotating when you are using a very
fine setting. If the grinding mechanism still refuses to
rotate, then it may be choked or blocked. Unscrew
the adjustable screw
mechanism. Release the stuck pieces by shaking the
grinding mechanism, then tighten the adjustable
screw again.
8
back on the base with contai­
firmly and
6
aligns with the symbol
1
.
6
from the bot­
7
before use
6
pushed to activate
2
on the
9
clockwise to
8
anticlockwise to
8
and loosen the grinding
8
GB/MT
15.08.14 12:30
6
2
21