Publicidad
Idiomas disponibles
Idiomas disponibles
Please call 1-888-266-7096 for service and
location of nearest authorized service center.
Please call 1-888-266-7096.
TO REPLACE CUTTING LINE
REMOVE THE SPOOL
For easy spool replacement we recommend using
Craftsman 71-85967, bump feed replacement spool with
0.065 cutting line. It is factory wound for maximum
reliability.
Disconnect the trimmer from the power supply. Turn
trimmer over to access spool head cover.
To avoid injury, ALWAYS turn off and
disconnect the trimmer from the power outlet BEFORE
installing parts or cleaning the trimmer or making any
adjustments.
Press the release tabs on the spool head cover and
remove cover, pulling it straight off of spool.
Lift the spool out of the spool housing.
See Figure 14, page ii.
REPLACE THE SPOOL
Replace the spool with a new factory pre-wound spool,
Craftsman 71-85967, available from your Sears store or
other Craftsman outlet.
Insert the end of one line through an eyelet in the spool
housing. Insert the other line through the other eyelet.
Insert the spool into housing and press it down gently
until you feel it drop into place.Take care to keep the
line from becoming trapped under the spool.
Snap the spool head cover back on and at the same
time pull lines and be sure that they are released from
spool rail notch.
FILLING SPOOL WITH CUTTING LINE
See Figure 15, page ii.
Replacement packs of 0.065 inch (1.65mm) Craftsman
Cutting Line 71-85822 are available from your Sears store.
Remove the empty spool from the tool as described in
"REMOVE THE SPOOL".
Remove any remaining cutting line from the spool.
First wind new line onto the uppermost part of the
spool. Feed 3/4 inch of cutting line into one of the line
spool rail notches. Wind the cutting line onto the spool
in the direction of the arrow on the spool. Make sure to
wind the line neatly and in layers Do not crisscross.
FILLING SPOOL WITH CUTTING LINE
See Figure 15, page ii.
When the wound cutting line reaches the eyelets
(recesses), cut the line. Temporarily park the line in
the spool rail notch on one side of the spool.
Repeat the above procedure for the second cutting
line on the lower section of the spool.
Fit the spool onto the tool as described in "REPLACE
THE SPOOL".
Before you begin trimming, only use
the appropriate type of cutting line. Ensure that cutting
line is present in both sections of the spool.
Publicidad
