Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING PICKUP TRUCK - TAILLIGHT MOUNTING
NOTE: No changes are necessary for OEM taillight fasteners. The taillight mounting
screws can be removed with an 8mm wrench after liftgate is installed.
NOTE: The fi ller strips in the kit
will bridge the gap between
liftgate and pickup bed. It is
important to fasten the fi ller
strips to Liftgate before install-
ing the Liftgate on the truck.
1. Butt the 3 fi ller strips (Kit item) end-
to-end to make 1 long strip at the top
rear edge of the main frame housing
(FIG. 10-1). Position each strip so the
short fl ange and screw hole is butted
against the back of the housing
(FIG. 10-1). Ensure the top surface
of each fi ller strip is fl ush with top
surface the housing.
CAUTION
Before drilling holes in the main
frame housing, ensure there are no
obstructions to drill bit or no items
that could be damaged by drill bit.
2. Use each fi ller strip as a template to
mark and drill hole in back of the main
frame housing (FIG. 10-1).
3. Fasten each fi ller strip to main frame
with a #12 x 3/4" long self-drilling
screw (bagged bolts) (FIG. 10-1).
LIFT CORPORATION Sht. 10 of 52 DSG#
INSTALLING FILLER STRIP
M-16-32
MAIN FRAME
HOUSING
FLANGE WITH
SCREW HOLE
POSITIONING FILLER STRIPS
Rev. B Date: 09/21/18
#12 SELF-TAP
SCREW (3 PLACES)
FLUSH
FILLER STRIPS
FIG. 10-1
Publicidad
