Troubleshooting - Silverline 270289 Manual De Instrucciones

GB

Troubleshooting

Problem
Router will not operate
Router runs or cuts slowly
Makes an unusual sound
Excessive vibration
Heavy sparking occurs inside motor
housing
8 8
Possible cause
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or short circuited
Blunt or damaged cutter
Variable Speed Dial (3) set low
Mechanical obstruction
Armature has shorted sections
Incorrectly fitted or loose router bit
Bent or damaged router bit
Brushes not moving freely
Armature short circuited or open circuited
Commutator dirty
Solution
Check that power is available at source
Have carbon brushes replaced by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Have the tool repaired by an authorised Silverline service centre
Resharpen or replace cutter
Increase variable speed setting
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre
Refit or tighten router bit
Replace router bit
Have carbon brushes checked and replaced by an authorised Silverline service
centre
Have the tool serviced by an authorised Silverline service centre
Have the tool serviced by an authorised Silverline service centre