Motor Connection - Erreka VIVO-D203 Guía Rápida De Instalación Y Programación

Operator connections for sliding gates and up-and-over doors
ST1: open
ST2: close
DL1: LED SGN1 (encoder) A1
DL2: LED SGN2 (encoder) A1
DL3: LED SGN1 (FCA) A1
DL4: LED SGN2 (FCC) A1
Operator connection
Single encoder
connection
(C701)
Connector E1: Connector E2:
V+: brown wire V+:
GND: mesh GND: common (COM) GND: mesh
SGN1: green or blue SGN1: opening (FCA)
wire
SGN2: do not connect SGN2: close (FCC)

In sliding gates (C302) and up-and-over doors (C303) it is only possible to use a single motor
(M1), which should be connected to the "MOTOR 1" cable connectors.
When using a single encoder (C701, C704) or dual encoder (C703), always connect to the
"ENCODER 1" cable connectors.
When using limit switches (C702 or C704), always connect to the "ENCODER 2" cable connectors.
(parameters C302 and C303)
Limit switches Dual encoder
connection
(C702)
Connector E1:
do not connect V+:
SGN1: green or blue
SGN2: yellow wire
A1: Operator 1
E1: "ENCODER 1" cable connectors
E2: "ENCODER 2" cable connectors
connection FC and single encoder connection (C704)
(C703)
Connector E1:
brown wire V+:
GND: mesh
SGN1: green or blue
wire
SGN2: do not connect SGN2: close (FCC)

Motor connection

G1: red wire
G2: blue wire
Connector E2:
brown wire V+: do not connect
GND: common (COM)
SGN1: opening (FCA)
wire
11