Troubleshooting; Specifications - Craftsman 316.292600 Manual Del Operador

MOTOR WILL NOT START
C A U S E
1. Unit is unplugged
2. Starter button or bail improperly used
3. Overload protection switch has popped out
For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts &
NOTE:
Repair center (1-800-4-MY-HOME ® ) or other qualified service dealer for an adjustment.
MOTOR
Engine Type ..........
Operating RPM............
Ignition Switch.
Amperage ...............................
Overload Protection ............................................................................................................................ 120 V 5 amp Breaker
CULTIVATOR*
Drive Shaft Tube ...................
Handle ..................................
Cultivating Path Width (Maximum) .........................................................................................................9 inches (22.86 cm)
Cultivating Depth (Maximum) .................................................................................................................6 inches (15.24 cm)
Approximate Weight ....
*All specifications are based on the latest product information available at the time of printing. We reserve the right to
make changes at any time without notice.

TROUBLESHOOTING

1. Make sure that extension cord is securely plugged
2. Press starter button and hold it in while squeezing
3. Depress overload protection switch. Follow starting

SPECIFICATIONS

13
A C T I O N
into cultivator's cord outlet receptacle on one end
and a 110V outlet on the opposite end.
bail against the handle.
instructions.
AC 120 Volts Electric
up to 8,000 rpm
Bail Lock Safety Button
6.5 Amps
Steel Tube
Steel Tube
27 lb. (12.25 kg)