Connecting The Monitor - Medion AKOYA P53002 Manual De Instrucciones

Precautions
You can increase the service life of your TFT monitor by taking the following precautions:
Caution!
There are no parts which can be serviced or cleaned inside of the monitor housing.
• Before cleaning always disconnect the power line and all connection cables.
• Do not use any solvents, caustic or gaseous cleaning agents.
• Clean the display with a soft, lent-free cloth.
• Ensure that no water droplets remain on the screen. Water can cause permanent discoloration.
• Do not expose the screen to bright sunlight or ultraviolet radiation.
• Please keep the packaging material safely and use it exclusively to transport the monitor.
Included Equipment
Please check your new TFT Display for completeness. Notify us within 14 days after purchase if it is not complete. With your
TFT monitor you receive:
• TFT screen
• 15-wired Sub-D cable
• CD with operating instructions and drivers
Start-Up
Mounting the Monitor Stand
Mount the monitor stand as shown in the diagram. Perform this step before connecting the monitor.
Prepare Your Computer
If you have previously used your computer with a CRT monitor, you will need to make sure that your computer's display settings
are supported by your TFT monitor. The following pages describe how to verify and change your display settings.
Supported Monitor Settings
WXGA Resolution
Caution!
If your display settings exceed the capabilities of your monitor, your monitor may show only a blank display.

Connecting the Monitor

• Operate your TFT monitor only with grounded outlets with AC 100-240V~/ 50-60 Hz. If you are not sure about the power
supply at your location, check with your power company.
• Use only the power connection cable provided.
• For additional safety we recommend use of a surge protector to protect your TFT monitor from damage resulting from
voltage surges or lightning.
• To remove the TFT monitor from the power supply, disconnect the plug from the AC outlet.
• The power outlet must be in the vicinity of your TFT monitor and within reach of the power cables. DO NOT stretch the
power cables tightly to reach a power outlet.
• You should arrange the TFT monitor cables in a manner that no one can trip over or step on them.
• To avoid damage of cable do not place any objects or furniture on the cable.
• Your device has an On and Off switch. The TFT monitor can be switched on or off by means of it. No electricity is consumed if
the switch is at OFF (0).
2
• Stand
• DVI-D cable
• Guarantee card
Ill.: Mounting the monitor stand
1440 x 900 @ 60 Hz*
English
• Quick start guide
• Audio cable
• Power cord
*recommended resolution (physical)