Cleaning and maintenance
Press the
and
keys at the same time
to make the symbol
screen after changing the filter. The symbol
disappears from the screen and the filter is
operational again.
Fitting the purifying filter (double
active)
• Check that the purifying filter is fitted in
the positioner. If it is not, fit it as shown
in Fig. 29. The black part of the filter
should be in contact with the positioner.
Fig. 29
• Remove the basic filter from the
appliance, Fig. 28.
• Insert the purifying filter + positioner
inside the basic filter as shown in Fig.
30, remembering that it must be housed
on the lower studs first.
clack!
2
clack!
Fig. 30
• Install the assembly onto the appliance
by lining the lower studs up with the
slots on the front casing of the appliance
and pressing the top tab in until it clicks
into position. The assembly is fitted
properly when it clicks into position.
• Close the front flap.
disappear from the
1
71
Important!
Fit only one set of filters onto the
support in order to ensure correct
appliance operation.
Notes:
The front flap can also be removed in
order to clean the appliance or change
the filters more easily. To do this, open
the flap up to the safety stop (the flap
opens to a slight angle, Fig. 25) and pull
outwards firmly. In order to refit it, line
the lower studs on the flap up with the
holes on the casing until the studs meet
the tabs on the casing.
Storage requirements
When the appliance is out of use for a
long period, fit the outdoor unit onto
the indoor unit so that the appliance
takes up as little space as possible. See
"Transportation requirements".
• Wind the hose up and secure it with
clamp B, Fig. 1. Fig. 31.
Fig. 31
Prior to use at change of season
• Clean the basic filter and, if necessary,
change the purifying filter.
• Then clean the upper and side air
directors to eliminate dust and dirt.
• Remember to unwind the hose carefully
when preparing the appliance for use
(see Important Information).