Torin BIG RED JACKS TR4055 El Manual Del Propietario página 12

TO ADD JACK OIL
The hydraulic cylinder assembly contains hydraulic
fluid that must be kept at approximately 80% full at
all times for proper operation. To check the level and
to fill remove bleeder screw (29)
1. Position the jack on level ground and lower the
saddle in the upright position. Open release valve
by turning handle counter-clockwise (4 full turns).
2. Locate and remove oil filler plug.
29
3. Fill the oil case until oil level is just beneath the
lower rim of the oil fill hole.
4. Replace oil plug.
5. Perform the Air Purge Procedure.
TO REPLACE JACK OIL
1. Position the jack on level ground and lower the
saddle in the upright position.
2. Open release valve by turning handle counter-
clockwise (4 full turns).
29
3. Lay the jack on its side and drain the fluid into a
suitable container.
Note: Dispose of hydraulic fluid in accordance with
local regulations.
4. Position the jack on level ground.
5. Fill the oil case until oil level is just beneath the
lower rim of the oil fill hole.
KEEP DIRT AND OTHER MATERIAL CLEAR
WHEN POURING.
6. Replace bleeder screw.
7. Perform the Air Purge Procedure.
12