Empty The Container; Daily Or As Needed; Checking/Cleaning Dust Filter; Suction Hose Storage - Kärcher KM 100/100 R Bp Manual De Instrucciones

4 Operations
4.1 Vacuuming
The key switch of the sweeper must be in position 1 (in-

itial startup) for the suction function.
Vacuuming can be done from the driver seat.

If the suction pipe is pulled out of the intake (contact

switch), the suction turbine switches on automatically.

4.2 Empty the container

4.2.1 Daily or as needed

Empty the container no later than when half of the fill
height is reached.
Take the suction hose out of the supports.

Open and secure the cover (see operating instructions

of the sweeper).

4.2.2 Checking/cleaning dust filter

4.3 Suction hose storage

Note
The suction turbine switches off automatically after 10 min-
utes of continuous vacuuming. If the work is to be contin-
ued, reinsert the suction pipe into the intake and pull it out
again.
Open lid cap (2x) on the container, tilt the lid to the side.

Open the container closure on the metal strip, remove

the container.
Empty, reinsert and secure the container.

Check dust filter and seal, clean if necessary.

1 Container
2 Wing nut
3 Dust filter
4 Container lid
5 Seal
Unscrew the wing nut, pull off the dust filter.

Check/clean dust filter, replace if necessary.

Clean seal, apply silicone grease.

DANGER
Risk of accident, risk of injury!
Store the suction hose in the supports when not in use.

1 Intake for suction pipe (with contact switch)
2 Support suction hose
3 Suction hose
Place the suction hose in the intake.

Store the suction hose between the two supports under

tension as shown.
2
-
EN 5