Refilling Water During Operation - Concept Perfect Clean CP 1010 Manual Del Usario

EN

REFILLING WATER DURING OPERATION

CAUTION: To avoid burn injury, do not refill water tank before steam cleaner has cooled completely. Be
careful when removing water fill safety cap. Even when cap is able to be turned the steam cleaner may still
be hot, especially the metal surfaces.
1. Unplug power cable from wall outlet.
2. If the water tank is still under pressure, the cap will be raised upwards and cannot be unscrewed. As soon
as the steam cleaner cools down and the pressure in the appliance drops, the cap retracts and can be
unscrewed.
3. It takes about 7-10 minutes to the steam cleaner to cool down, the safety cap will drop totally. If it do not
drop after 10 minutes, release the remaining pressure by pressing the steam discharge button again.
Turn clockwise to unscrew the filler cap and remove the cap gently. DO NOT EXCEED THE FILLING OF
THE FILLING HOLE. Allow the steam cleaner to cool for another 5 minutes. After the steam cleaner has
cooled down and the pressure is reduced in the appliance, the filler cap will easily release. Fully unscrew
the filler cap.
.
4 Pour all the remaining water to prevent the tank from overfilling and pour 300 ml of water into the steam
cleaner tank using a measuring jug. (The maximum capacity of the water tank is 300 ml. Do not overfill
the reservoir, leave a smaller gap at the top.)
5. Re-install the water fill safety cap in a clockwise direction and tighten until it is completely sealed.
6. DO NOT OVERTIGHTEN THE SAFETY CAP.
IMPORTANT: DO NOT ADD CLEANING SOLUTION TO THE WATER TANK.
82
C P 1010