Fanimation ROTATION FP8018 Serie Manual De Usuario página 9

How to Hang Your Ceiling Fan (continued)
2. Attaching Ceiling Support Cable (Figure 4): Drill
¼˝ pilot hole through into the ceiling joist or structural
member. Securely attach the ceiling support cable with
⁄ ˝ x 2˝ lag bolt and fl at washer.
3
8
NOTE: Ceiling support cable must be directly secured
to ceiling joist or structural member between fl at washer
and junction box with 2˝ lag bolt (Figure 4).
3. Hanger Bracket Attachment:
Securely attach the hanger bracket to the outlet box
using the outlet box screws and washers supplied with
the outlet box (Figure 4).
4. Assemble and secure the assembled fan with hex-
head bolt, two lockwashers, nylon locknut and clevis pin.
(Figure 5)
▲WARNING
It is critical that the clevis pin and lock nut in the hanger
bracket/downrod area is properly installed. Failure to
verify that the nut and hairpin clip are properly installed
could result in the fan falling.
INSTALLATION NOTE
The hanger bracket angle adjustment MUST ONLY be
used to orientate the downrod in a vertical downward
position.
5. (Optional) Sloped Ceiling Installation (Figure 6):
Loosen two nuts located on both sides of the hanger
bracket to orientate the downrod in the vertical position.
6. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger bracket
and the junction box so that electrical connections can be
made later.
7. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and fi rmly tighten screw (Figure 7). Cut
off excess safety cable.
▲WARNING
To avoid possible shock, do not pinch wires between the
downrod and the hanger bracket.
(2" x 4" Approx.)
Ceiling
Ceiling
Support
Cable
Sloped
Ceiling
NOTE: Supply wires and
fan wires omitted for clarity
9
Ceiling Joist
Wood Member
Junction
Box
Hanger Bracket
Figure 4
Downrod
(Assembled Fan)
Figure 5
Loosen Nuts on
both sides of the
Hanger Bracket
Figure 6
Attach
Safety Cable
to Ceiling
Support Cable
Figure 7