Mounting The Sink - Glacier bay 14-028-W Guía De Uso Y Cuidado

Installation
1
Installing the anchors
NOTE:
It is recommended this be done by a
professional.
Using the template (B) as a guide, mark the four hole

locations for the mounting hardware on the countertop.
Using a 5/16 in. diamond bit, drill a 1/2 in. deep hole in

each location.
Clean the holes and apply quick set epoxy.

Place one threaded knurl (BB) into each hole, and allow

to cure for the amount of time required according to the
epoxy manufacturer's directions.
BB
3

Mounting the sink

With the countertop positioned upside-down, center the

sink (A) over the cutout.
Firmly press the sink (A) onto the countertop, and immediately

wipe off excess sealant.
Attach the undermount clips (AA) to the threaded knurl (BB) in

the countertop using the machine screws (CC) and washers
(DD) to hold sink (A) in place.
Allow the sealant to set for 30 minutes before proceeding.

Flip the countertop right-side up, and install it onto the

cabinet.
2
Applying the sealant
Make sure the surface to be sealed is clean, dry, soap free,

oil free, and grease free.
Apply a continuous bead of quality sealant around the top

side of the sink (A) rim near the edge.
NOTE: It is recommended to practice the proper
positioning two or three times before applying sealant.
A
CC
DD
AA
BB
6
A