Publicidad
Step 11
1
H
D36
å
Pull the DRAWER FRONT BRACKETS (9G) apart and slide them
into the grooves in the DRAWER SIDES (D36 and D37). You may
need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
"LH" for easy identifi cation.
å
Fasten the LARGE DRAWER FRONT (H) to the DRAWER FRONT
BRACKETS (9G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
M67
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M67) to the LARGE
å
DRAWER FRONT (H). Tighten one HIDDEN CAM.
www.sauder.com/service
Push down
9G
D37
Groove
BLACK 9/16" LARGE HEAD SCREW
(20 used in this step)
Maximum
Arrow
210 degrees
Minimum
190 degrees
Hidden part using
recycled material.
Color may vary.
H
VIEW THE T-SLOT BOX VIDEO
2
D36
1S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D974) into the grooves
å
in the DRAWER SIDES (D36 and D37) and LARGE
DRAWER FRONT (H).
4
D36
M67
å
Fasten the DRAWER BACK (D167) to the DRAWER
SIDES (D36 and D37) and DRAWER BRACE (M67). Use
fi ve BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the other drawers. Use the SMALL
DRAWER FRONT (I), SMALL DRAWER SIDES (D42
and D43), SMALL DRAWER BACK (D165), and SMALL
DRAWER FRONT BRACKETS (7G) for the small drawers.
420456
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D974
U n fi
n i s h
e d
s u r
f a c
e
H
D37
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(30 used in this step)
D167
D37
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 15
Publicidad
