Axis T90C10 Guia Del Usuario página 11

AXIS T90C10/T90C20 Fixed Dome IR-LED User Guide
AXIS T90C10
When camera lens faces left
1. Remove 2 screws located on the top on either side of the LED block and detach the LED block.
2. Move the ferrite to the center (see image below).
3. Remove 2 screws on the control board and fasten the control board to the right.
4. Align the LED block with the screw holes to the left and fasten the 2 screws again.
When camera lens faces right
1. Remove 2 screws located on the top on either side of the LED block and detach the LED block.
2. Move the ferrite to the center (see image below).
3. Loosen the cable gland and pull a greater length of the cable so it can reach the left side of the
IR-LED.
4. Remove 2 screws on the control board and fasten the control board to the left.
5. Fix the LED block to the right (see image below).
LED block to the center
2 screws on LED block
LED block
2 screws on control
board
LED block to the left
LED block to the right
Cable gland
Control board
Ferrite
Page 11
LED block