Garmin GHS10 Instrucciones De Instalación página 2

GHS 10/10i Installation Instructions
These installation instructions are for
the GHS 10 and GHS 10i handsets.
The GHS 10 is for use with the Garmin
VHF 200 radio and the GHS 10i is for
use with the Garmin VHF 200i radio.
For additional information, refer to the
VHF 100/200 Series Radio Installation
Instructions that came with your radio.
For operational instructions, refer to
your VHF 100/200 Series Radio Owner's
Manual.
The handset comes with a 32.8 ft. (10 m)
extension cable, a bulkhead mounting
plate, a weather cap, and the necessary
cable hardware.
Install the GHS 10 or GHS 10i
handset at least 20 in. (500
mm) from any compass.
GHS 10/10i Installation Instructions
To connect the GHS 10 or GHS 10i
handset:
1. Using the mounting plate as a
2. Use a pencil to trace the cable hole in
3. Use a ⅞ in. (22 mm) hole saw to cut
4. Use a ⅛ in. (3 mm) drill to drill the
External speaker
wires
template, use a center punch to mark
the three screw locations on the
surface.
the center of the mounting plate. Set
the mounting plate aside.
the cable-mounting hole.
three mounting-plate holes.
Weather cap
Cable-mounting
hole
Mounting
plate
Cable nut
EN-1