Publicidad
Idiomas disponibles
Idiomas disponibles
and disinfection does not start, refill the disinfectant.
It is prohibited to use or enter the water used for
disinfection.
If, for any reason, the disinfection cycle is stopped (by pressing
the alarm button), the relative button to advise that disinfection
has not been completed remains highlighted.
To eliminate this message, run a new complete disinfection cycle.
Chromolight Menu:
From the main menu, use button 4 to access the Chromolight
menu.
A
The chromolight can be turned on and off using the ON/OFF
button on the lower right.
The A buttons allow you to select the Chromolight program.
Dream and Dynamic Chromolight Programs:
Chromolight uses 4 standard colors: Red, Violet, Blue, and
Green.
If you select the color you want, the color will be constant.
You can also select from four chromotherapy programs:
RAINBOW _ uses all the DYNAMIC - DREAM -
RELAX programs in sequence.
DYNAMIC _ program based on warm red tones
for an energizing massage
DREAM _ program based on blue tones for a
relaxing massage
RELAX _ program based on green tones for a
relaxing massage
Time Adjustment Menu:
From the main menu, press and hold down on the time display
until the adjustment sub-menu appears.
h _ Adjust the hour using the + and - buttons.
m _ Adjust the minutes using the + and - buttons.
Press the HOME button to confirm and return to the main menu.
12:33
A
ON/OFF
For your safety, there is an alarm button on every page. If
pressed, it disables all active functions and returns to the main
menu.
To deactivate the alarm, press the button 6 or 5.
FLUSHING:
To empty the piping, the tub is equipped with a flushing system.
• If the whirlpool is used about 30 minutes after draining the tub,
the blower starts automatically (for about 1 minute) in order to
expel any residual water in the piping.
• If the tub is used without the whirlpool function, the piping
must be flushed manually.
To do this, on the whirlpool menu, pres and hold down
button 7 for 4 to 5 seconds, until the blower starts.
After 1 minute the blower will turn off automatically.
Description of remote control
Inserting/replacing the batteries:
Before inserting the batteries, make sure the power unit is
powered up.
The remote control takes ALKALINE AAA LR03 1.5V batteries
(supplied). When flat, they must be replaced with two new
batteries of the same type.
Insert the batteries respecting the polarity.
Before closing the door, make sure the water gasket is in
place.
-39-
ENGLISH
12:33
h
m
NO
OK
Publicidad
