SATA HF0204 Manual Del Uso página 4

KN95 Particulate Respirator :
Operating instruction:
Product description: KN95 Particulate Respirator
Product type: HF0204 （KN95）
Materials: Outer punched nonwoven materials, which are non-toxic, odorless, non-allergenic, non-irritating and have good porosity.
Storage conditions: The mask shall be stored in a clean environment to prevent it from damage, fouling, dust, direct sunlight, high
temperature and harmful chemical contamination, etc. Meanwhile the mask must be stored in a proper way to avoid deformation.
Period of use: It is generally recommended to discard it after use every day, no longer than 1 week, to avoid secondary pollution; it can be
stored for three years under sealed conditions.
Product standards: GB2626-2006
Filter classification: KN type for protection against non-oil based particles
Reagent for checking filtration efficiency: sodium chloride particles
Filtration efficiency: ≥95.0%
Refer to the information provided by the manufacturer - Storage conditions: temperature: -10° C~60° C; humidity: 15%~90%
Notes:
1） Not for use in an oxygen-deficient environment with an oxygen content below 18%.
2） Not for use in an environment that immediately endangers life and health.
3） Can not be disinfected with a microwave oven.
4） Improper use of this product can lead to illness or even death.
5） This product shall not be used when there are hair, beard or others on the face that directly affect the airtightness between the face
and the edges of the mask. To maintain good airtightness between the face and the edges of the mask, the hair, headscarf or other
devices must be removed from the seal edges of the mask and the face during use.
Wearing instructions:
1） Before wearing a new mask, stretch the elastic headbands with hands in an interval of 2-4 cm.
2） Place the mask in the palm so that the metal nose clip directs towards the fingertips with the headbands hanging naturally.
3） Cup the mask under the chin with the nose clip upwards, pull the lower headband up and place it at the base of the neck and pull
the upper headband up and place it above the ears.
4） Place two of the fingertips on the top of the metal nose clip, gently conform/press the nose clip across the bridge of the nose by
pressing down with fingers until it fits snug.
Please use both fingertips instead of one fingertip to conform/press the nose bridge, otherwise, it may result in improper snugness
and reduce the protective performance of the mask.
Note: Please refer to the Operating Instructions and Wearing Instructions for proper use and maintenance of this product.
Manufacturer: Dongguan Makrite Industrial Ltd
4
HF0204/HF0204V
中文
EN DE RU KO PT JA ES