SATA 03025 Manual Del Uso página 18

touching the head or the measured
conductor. When the meter is held
by hand, the fingers shall not go
beyond the insulated gate.
3. Trigger:
It is used to control the opening and
closing of the head.
4. Flashlight switch button
5. Function switching button
03025: This button is used for
function switch among resistance,
continuity and diode.
03026:This button is also used for
function switch among AC, DC, AC
and DC voltage.
6. "Hz%" function button
I t i s u s e d t o sw i t c h b e t w e e n
frequency measurement mode and
duty cycle measurement mode.
7. LCD
8. "COM" jack: Input jack of black
probe.
9. "INPUT" jack: Input jack of red probe.
10. 03025: "REL" button, used to enter and deactivate the relative value measurement mode.
03026: "REL/ZERO" button, used as a zero setting button during DC test.
11. Function/position switch
This switch is used for selecting desired function and position, and switching on or off
meter power.
12. "HOLD" button and backlight button
* Press the button for data hold;
* Press and hold this button for about 2 s to turn on or off the backlight. The backlight will
be turned off automatically about 15 s after turned on.
13. Flashlight source
03025/03026
- 03 -
16
EN EN DE DE RU RU KO KO PT PT JA JA ES ES