SATA AE5401 Manual Del Uso página 46

3.4 Installation of lifting platforms
Insert adjusting sizing blocks under the platform, lift the lifting platform with a forklift or other lifting equipment (Fig. 5) to about 1000MM,
so as to ensure that the mechanical safety device is activated and locked.
- To avoid the failure of the mechanical safety device, a wood block can be inserted at the middle of the
connecting rod. When the hydraulic system is not fully filled with hydraulic oil and has the lifting and lowering
actions, do not work under the lift. Move the lifting platforms, adjust the distance between two platforms to
make them parallel, and connect the electric circuit, oil circuit and air circuit of two platforms as specified in
the Wiring Diagram and Oil Circuit Connection Diagram. Only after the hydraulic system connection is completed,
the pneumatic circuit connection can be conducted, and the oil pipes, electric wires and air pipes cannot be
damaged. When inserting the oil pipes and air pipes into the pit from the control cabinet via PVC ducts, pay
special attention to the protection of pipe joints so as to prevent the damage to hydraulic system caused by
foreign matter entering the oil circuit and pneumatic circuit.
- Connection of electrical circuit: connect the electrical circuit according to the wire diameter and wire size
specified in the Wiring Diagram.
46
AE5401/AE5401-3
中文
Fig. 5
EN DE RU KO PT JA ES