Product Specifications - Homewerks 21-B42-WYHW-Z Manual De Montaje

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. flow rate: 1.2 GPM (4.542 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome or brushed nickel finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Place faucet (A) through mounting
holes in sink. Secure faucet (A) to
sink using the rubber washer (AA)
and mounting nuts (BB).
3. Make connections to water lines.
Use 1/2 in. IPS faucet connec-
tions (3.1) (not included) or use
coupling nuts (3.3) with 3/8 in.
OD ball-nose riser (3.2) (not
included). HAND TIGHTEN. DO
NOT OVERTIGHTEN. Do not use
PTFE pipe tape, plumber's putty,
pipe dope or any other type of
sealing compound on water inlet or
threads. Addtional compound is
not necessary. A water tight seal
between the thread inlet and
supply tube is acheived by
compression.
4. Remove preassembled flange
(4.1) from pop-up assembly (B).
Leave preassembled large black
washer (4.2) and nut (4.3) on
pop-up assembly (B).
1
2
A
BB
AA
3
3.2
3.1
3.3
4
4.1
B
4.2
4.3
Washerless cartridge
Manufactured to include no more than 0.25% weighted
average lead content on wetted surfaces
5. Place flute washer onto drain
body and slide drain body down
through the drain opening from
the top of the sink.
6. From underside of the sink,
slide the rubber washer with
beveled side down toward sink
onto the drain body. Secure the
drain body to the sink using nut.
DO NOT OVERTIGHTEN.
7. Important: After installation is
completed, remove aerator (7.1)
from faucet (A). Turn on water
supply and allow both hot and
cold water to run for at least one
minute each. While water is
running, check for leaks.
Replace aerator (7.1). Tighten
nuts slightly to stop minor leaks.
If problems persist, refer to
troubleshooting.
2
SPECIFICATIONS
5
6
7
A
7. 1
www.homewerksww.com