Install The Cutting Line; Transportation And Storage; Move The Machine; Store The Machine - GreenWorks STE304 Manual Del Operador

10.4

INSTALL THE CUTTING LINE

Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
Spool
cover
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
Hole
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap counterclockwise to wind the cutting
line into the trimmer head. Keep approximately 5 in of
cutting line above out of each side of the trimmer head.
NOTE
Bump
head
English
11 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before

transportation and storage.

11.1

MOVE THE MACHINE

When you move the machine, you must:
• Stop the machine.
• Remove the battery pack.
11.2

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
12

TECHNICAL DATA

Type
Motor
No load speed
Cutting line diameter
Cutting path diameter
Feed Type
Weight (without battery
pack)
Battery model
Charger model
11
WARNING
Cordless, battery powered
48V (2 x 24V)
13in.:6500±10%RPM(high),
5800±10%RPM(low);
15in.:6000±10%RPM(high),
5300±10%RPM(low)
0.080" (2.0 mm)
13 in./15 in. (330 cm/381
cm)
Bump Feed
7.9 lbs (3.6 kg)
BAG708 and other BAG
series
CAG812 and other CAG
series
EN