Wayne Dalton Prodrive 3220C Instrucciones De Instalación Y Manual Del Propietario página 21

19
Setting Door Close Travel
Tools Needed: Using the wall control up/down button,
activate door to full open position;
Flat Tip reactivate to close position.
Screwdriver
The door should stop on the floor with the
bottom door seal slightly compressed.
If the door reverses off the floor, turn close
travel knob 1/4 turn "less".
If door is not completely closed, turn travel
knob 1/4 turn "more".
Repeat as necessary.
NOTE: 1/4 turn equals 1" of door travel.
20
Setting Door Opening Travel
The door opener is assembled with the open
Tools Needed:
travel adjustment preset for a typical door,
but all doors should be adjusted to stop as
Flat Tip
close as possible to the door's "natural" fully
Screwdriver
open, resting position.
To determine the door's "natural" fully open,
resting position, disconnect door from
opener using the emergency release
disconnect (see page 27, EMERGENCY
DISCONNECT) and manually raise door to its
"natural" fully open, resting position. Use this
location for your open limit setting. To
determine if door needs adjustment, activate
the opener to bring door to fully open
position.
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Bottom Of Opener
TRAVEL ADJUSTMENT
OPEN CLOSE
LESS
MORE MORE
Bottom Of Opener
TRAVEL ADJUSTMENT
OPEN CLOSE
LESS
MORE MORE
15