SATA 96411 Manual Del Uso página 15

96411 / 96412
Warning
Do not tilt the wrench handle while using it. Tilting the wrench handle easily results in a deviation of torque value or
even a damage to the fastener.
While tightening the fastener, be sure to evenly apply a force on the torque wrench (as shown in figure).
As the resistance increases, the application rate shall slow down accordingly.
- Do not continue applying the force after the preset torque, and immediately stop the force after hearing the "click"
sound to ensure the output accuracy of torque and prolong the service life. The continuous force application may not only
cause the damage to torque wrench itself, and also cause the actual output torque value to greatly exceed the set torque
value, thereby damaging the nut. When the wrench is set at the low torque value, the "click" sound will be lighter
than that at the high toque value. Therefore, when outputting a low torque value, pay special attention to the "click"
sound.
EN DE RU KO PT JA
- 03 -
15
ES